Self-Adhesive Embroidery sticker Patch - Iron on Scarf Label - Bear Sticker Patch

Self-Adhesive Embroidery Patch

Material: Towel Embroidery

Size: may refer to picture

quantity : 1 unit

suitable for for clothes, handmade item, and etc...

【How to Iron On the Patch】

1.First, tear off the protective film on the back, place the patch on your desired position, with the side that has the hot melt adhesive facing the fabric (do not peel off the glue).

2.Preheat your iron, then press the patch firmly from the front side for 10–20 seconds to fix its position. You can also use pins or a few stitches to hold it in place to prevent shifting.

3.Turn the fabric (or garment) inside out and iron from the back side for 30–60 seconds to ensure the adhesive fully melts and bonds the patch securely.

4. Finally, iron the patch again from the front side for 1–2 minutes, focusing on the edges and corners to make the surface smooth and blend well with the fabric.

【Notes】

1. If the patch has sequins, beads, rhinestones, silk flowers, pom-poms, or metallic threads, first iron it from the back side to secure it, then carefully press the front edges if needed — this helps avoid damage to the decorations.

2. Ensure the fabric stays dry. Do not spray water onto the patch or fabric while ironing.

3. When done properly, the patch will stay attached for a long time. If it falls off after some time or after washing, it may mean the iron was not hot enough or the time was too short — simply repeat the steps to re-iron the patch.

【Cara Menampal Patch dengan Seterika】

1. Letakkan patch di tempat yang anda inginkan dengan bahagian gam pelekat menghadap kain (jangan tanggalkan gam).

2. Panaskan seterika, kemudian tekan patch dari bahagian depan selama 10–20 saat supaya kedudukannya tetap. Anda juga boleh jahit sementara atau semat dengan pin supaya patch tidak bergerak.

3. Terbalikkan kain (atau pakaian) dan seterika dari bahagian belakang selama 30–60 saat supaya gam cair sepenuhnya dan patch melekat dengan kuat.

4. Akhir sekali, seterika sekali lagi dari bahagian depan selama 1–2 minit, fokus pada bahagian tepi dan sudut supaya permukaan licin dan tampalan sebati dengan kain.

【Perhatian】

1. Jika patch mempunyai labuci, manik, batu kristal, bunga kain, pom-pom atau benang logam, seterika dari bahagian belakang dahulu sehingga patch melekat, kemudian betulkan tepi dari bahagian depan dengan berhati-hati supaya hiasan tidak rosak.

Pastikan kain kering sepenuhnya.

2. Jangan sembur air semasa menyeterika patch atau kain.

3. Jika dipasang dengan betul, patch akan melekat lama. Jika tertanggal selepas beberapa ketika atau selepas dicuci, kemungkinan suhu seterika terlalu rendah atau masa terlalu singkat — ulang semula langkah di atas untuk melekatkan patch.